Dripping kitchen faucet
|

Faucet Dripping After It’s Turned Off? Fix It for Under $20

Disclosure: We may earn a commission when you buy through links on our site, at no extra cost to you.

Drip. Drip. Drip. A faucet that won’t stop dripping wastes a surprising amount of water and drives you a little crazy at night.

The fix is almost always one small part: a washer, an O-ring or a cartridge. The trick is figuring out what kind of faucet you have, so you buy the right one the first time.

Quick Picks at a Glance

ProductBest ForDeal
Faucet Cartridge (Match Your Brand)Single-handle faucetsCheck Price on Amazon
Faucet Washer and O-Ring KitTwo-handle faucetsCheck Price on Amazon
Plumber’s GreaseSmooth, sealed partsCheck Price on Amazon
Adjustable Wrench SetRemoving nutsCheck Price on Amazon
Faucet Handle PullerStuck handlesCheck Price on Amazon

Step 1: Turn Off the Water

Close the shutoff valves under the sink. Then open the faucet to drain pressure. Put a towel or plug in the drain so tiny screws don’t vanish forever.

Step 2: Figure Out Your Faucet Type

Two handles (hot and cold)

Usually compression or cartridge style. Older compression faucets use rubber washers that wear out.

One handle

Usually a cartridge or ball type. Most modern single-handle faucets use a cartridge.

Take a photo of the faucet and note the brand. The cartridge you need depends on the exact model.

Step 3: Remove the Handle

Pop off the decorative cap, remove the screw, and lift the handle off. If it’s stuck from mineral buildup, a handle puller saves the day without cracking anything.

Fix 1: Replace the Washer (Compression Faucets)

Unscrew the stem with a wrench. At the bottom you’ll find a rubber washer held by a screw. Swap it with one from a washer kit, and replace the O-ring on the stem while you’re there.

Fix 2: Replace the Cartridge (Most Single-Handle Faucets)

Remove the retaining clip or nut, pull the cartridge straight out, and take it to the store or match it online. Install the new one facing the same direction. Smear a little plumber’s grease on the O-rings.

Step 4: Reassemble and Test

Put everything back, open the shutoff valves slowly, and check for drips. If water leaks from the base instead of the spout, the O-rings need replacing.

When to Replace the Whole Faucet

If the body is cracked, parts aren’t available, or it’s leaking from multiple spots, a new faucet may be the better buy. Installing one is a moderate DIY job.

Keep Reading

Shower Drain Clogged With Hair? · Low Water Pressure in the Whole House? · Toilet Keeps Running After Flush? · 15 Home Maintenance Tools Every DIYer Should Own

FAQ

Why does my faucet drip after I turn it off?

A worn washer, O-ring or cartridge lets water seep past. Replacing the worn part usually fixes it.

How much water does a dripping faucet waste?

It can add up to many gallons a week, depending on how fast it drips.

Do I need a plumber to fix a dripping faucet?

Usually not. Most drips are a simple part swap with basic tools.

How do I know which cartridge to buy?

Check the faucet brand and model, or bring the old cartridge to the store to match it.

Why is my faucet leaking from the base?

Usually worn O-rings. Replace them and add plumber’s grease.

Similar Posts

Leave a Reply

Your email address will not be published. Required fields are marked *